Condensing Water Heaters - Specification
Rinnai water heaters will never run out of hot water
-
As long as electricity, water, and gas supplies are connected, hot water is available when hot water taps are open
-
DIP switches to enable temperature setting
-
All Rinnai HDC internal water heaters are room-sealed, power flue appliances. The external weatherproof models have forced exhaust. This makes them compact, saving both floor and wall space
-
For safety, the over-temperature protection will switch off the heater should the water temperature exceed by 3°C above its set-point
-
Low operating noise level of 50 db(A)
-
Integral frost protection to the water heater (power must be left ON)
-
LED displays the status of the water heater with diagnostic codes
Status monitoring for easier diagnostics
The status monitor has three conditions:
1 - The water heater is off (no water flowing): The LED is blank
2 - The water heater is on (heating water): The LED displays the set temperature
3 - The water heater should be on, but is not (water is flowing,
heater is not on):
The LED will flash a diagnostic code
BMS INTERFACE - optional
BMS Error Indication Switch Part Number 210-592-000
The Rinnai HDC Error Indication Switch is a volt-free normally open switch which will shift to a closed position when there is an active error in the water heater.
The switch is designed to be connected to a monitoring system, such as BMS (Building Management System), or another visual or audible error indication system.